Woohoo!!! got a call tonight... my glass has come in and ready for pickup!.. This weekend is glass weekend!!
New Tank
#42
Posted 14 June 2013 - 07:44 PM
GLASS IS IN! finally... So the glass is in.. now its back to waiting for it to cure so i can stand the tank back up and do the front bead of silicone.
Attached Files
#43
Posted 14 June 2013 - 08:14 PM
#44
Posted 14 June 2013 - 09:39 PM
i have siliconed all around the inside edge aswell so that should stop that aswell
#45
Posted 14 June 2013 - 09:44 PM
Been watching with great interest. Very nice job!
#46
Posted 16 June 2013 - 12:16 PM
Some more pics.. silicone work is done now with all the inside being done and today finished the black silicone on the front ...
Attached Files
#47
Posted 16 June 2013 - 12:33 PM
#48
Posted 20 June 2013 - 05:15 PM
Waiting is nearly over... Saturday is filling day, start filling sat morning fingers crossed!!
#49
Posted 20 June 2013 - 06:15 PM
#50
Posted 20 June 2013 - 08:57 PM
yep test fill it is
#51
Posted 22 June 2013 - 09:19 AM
1/4 full no leaks as yet..!
#52
Posted 22 June 2013 - 09:35 AM
pic
Attached Files
#53
Posted 22 June 2013 - 10:38 AM
Bugger Bugger and bugger.... got to 10cm from the top, just about full and then drip drip drip... theres a tiny pin hole in the back corner! Not the end of the world but a pain. shouldnt be too hard to fix.. just use the left over resin to clog up the hole.. im going to recoat the entire back corner to be safe. now just need to empty the tank and dry it out to do that...
so so close....
#54
Posted 22 June 2013 - 01:12 PM
#55
Posted 22 June 2013 - 03:19 PM
dont think the whole thing is going to need another coat, from what i can see at the moment its a really small airbubble in a corner thats done it .. so i might just fill it with silicone. But once its empty i will flip it and give it a good look over and if it needs another coat so be it..
but aside from that its worked out great.. the glass held up fine at 90% full aswell which i thought was were i would run into problems... apparently not
Edited by Zabick, 22 June 2013 - 03:20 PM.
#56
Posted 22 June 2013 - 08:32 PM
I have located the airbubble/hole that i think are causing the leak, dried it out and have injected some fast dry epoxy resin/glue into and over it, so hopefully round 2 will go better...
#57
Posted 25 June 2013 - 06:38 PM
**UPDATE**
The small air bubbles i had found have been repaired now, unfortunately i wont have time til this saturday to do another test fill.. stay tuned
#58
Posted 25 June 2013 - 06:48 PM
I'm surprised that you can wait that long.
#60
Posted 28 June 2013 - 08:04 PM
full pic
.. you might notice the very special fish my daughter decided to add for me..
Attached Files
Edited by Zabick, 28 June 2013 - 08:05 PM.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users